![]() In other words: The first crypto suite offered must be known to Zoiper otherwise, the call is not accepted. I'm not able to make outbound calls from my CME SIP gateway, below is the debug ccsip messages output, I'm getting a SIP/2.0 500 Server Internal Error as shown in the output below (IPs changed for security reasons), below the ccsip output is my outbound SIP config INVITE sip:+25472510124010.10.10.10:5060 SIP/2. ![]() In an incoming call, if the first crypto suite is unknown, the whole SDP is rejected with SIP status 415, even if supported crypto suites were offered. … (Additional) Encryption → SDES: Disabledĭoes not pick MD5, continues without header Authorization, therefore is not able to register therefore incompatible with Linphone 2 Answers Sorted by: 0 u forgot to add user1. Otherwise, incoming SDES-sRTP is rejected with SIP status Unsupported Media (415) To set it up, press the + in the top left corner. … (Additional) Encryption → ZRTP: Disabled Putting your Softphone in to Do Not Disturb mode will reject incoming calls. ![]() … (Additional) Network → Protocol suite: SSL v2/3 Tap on Incoming call channel and make sure that Show notifications option is turned ON. Here is debug ccsip messages: Dec 28 19:33:47. Nothing has changed in the config since it was working. I can make outgoing calls with no problem. number used when call is rejected on busy or for auto forward/transfer. Go to device’s Settings > Notifications & status bar > App notifications and find Zoiper. So yesterday I had a fully functioning Cisco CME with a Callcentric SIP trunk, and today incoming calls are failing with a '486 busy here' message. VoIP: SIP-over-TLS and sRTP: Securax Zoiper VoIP: SIP-over-TLS and sRTP: Securax Zoiper Last tested version 3.21 Note: MizuDroid can be used also for peer to peer calls without the need of a.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |